Knob-and-tube, cloth-insulated and ungrounded wiring replaced with modern grounded circuits in Clearfield — planned around your house, permitted, and warrantied for five years.
Rewiring is the job people put off longest and regret waiting on most. In Clearfield it comes up for a specific reason. Clearfield runs older near the base and Freeport Center and newer out toward the FrontRunner station, so a single street can hold a 1955 fuse panel and a 2019 200-amp service.
Clearfield runs older near the base and Freeport Center and newer out toward the FrontRunner station, so a single street can hold a 1955 fuse panel and a 2019 200-amp service. That history shows up in the work.
Rewiring an older house is a routing problem before it is an electrical one. Where the wire can travel through the structure decides how much finish comes off, and that decides most of the cost. We walk it and plan it before we open anything.
Rental and investment property is heavy here, and insurers are increasingly specific about hazard panels at renewal. We rewire throughout Clearfield and Davis County, and we can phase the work so the house stays livable while it happens.
The original wiring method in pre-1950 homes. It has no ground, its insulation embrittles with age, and insurers frequently will not write a policy over it.
Mid-century cloth-covered branch wiring cracks and sheds at the terminations, which is exactly where the heat is. Replacement is the only real fix.
Late-60s and early-70s aluminum branch wiring has known connection failure modes. Remediation ranges from approved connectors to full replacement.
Two-prong outlets throughout a house mean no equipment ground. Modern electronics and appliances assume one is there.
Not everyone can move out. We can rewire a floor, a wing or a circuit group at a time so the house stays livable through it.
Old lath-and-plaster and masonry construction decide the routing. We plan the access before we open anything.
Permits: we pull the Clearfield electrical permit where the work requires one and schedule the inspection.
Power company: Rocky Mountain Power serves Clearfield. We coordinate the meter disconnect and reconnect for panel and meter work.
Local conditions: Rental and investment property is heavy here, and insurers are increasingly specific about hazard panels at renewal.
You never deal with the city or the utility. That is our job.
We work throughout Clearfield and Davis County, including Freeport Center and Clearfield Station.
Look in the attic or an unfinished basement for individual wires running through white ceramic tubes and knobs rather than a single cable. If your house predates 1950 and has two-prong outlets, it is worth an inspection either way.
Many carriers will not write or renew a policy on active knob-and-tube, and some ask about aluminum branch wiring specifically. If your carrier has raised it, bring us the letter and we will scope to what they are asking for.
Often not. We can phase the work so you keep a functioning kitchen, bathroom and bedrooms throughout. Whole-house-at-once is faster and usually cheaper per circuit, and we will lay out both options.
Frequently, yes — a rewire is the natural moment to correct an undersized or hazard-brand service, and doing both together costs less than doing them a year apart.
Less than people expect. We fish where we can and cut where we must, and we mark the plan with you before anything opens. Patching can be included in the scope if you want it handled.
Run the numbers yourself with our free EV charger, panel-upgrade, energy and generator calculators. No email required.
Licensed, insured and ready now. Free estimates, upfront pricing, five-year warranty.