A Type 2 surge protective device installed at your panel in Roy — protecting the appliances, electronics and HVAC equipment that plug-in strips never reach.
The surge that kills electronics almost never arrives as a lightning strike. It arrives when the utility restores power after an outage, or when a large motor in the neighborhood cycles. With Hill Air Force Base next door, a lot of Roy homes turn over on a PCS timeline, and the home inspection is where an old panel becomes a negotiation.
Roy grew up around the base, which means block after block of 1950s-70s starter homes on original services, plus newer infill west of 1900 West. It matters more than it sounds like it should.
A device at the panel is the only thing that stands between that transient and everything hardwired in the house: the furnace board, the heat pump, the range, the well pump, the garage door opener. None of those are on a power strip.
With Hill Air Force Base next door, a lot of Roy homes turn over on a PCS timeline, and the home inspection is where an old panel becomes a negotiation. We install surge protection across Roy and Weber County, usually in a single short appointment, and we verify the grounding electrode system while we are there.
Installed at the service panel so everything downstream is covered, including the hardwired equipment a power strip cannot protect.
Furnace boards, heat pump controls and AC condensers are among the most expensive things a surge takes out, and none of them are on a power strip.
Modern ranges, refrigerators, dishwashers and washers are all computers with a heating element attached.
A surge device is only as good as the ground it discharges into. We verify the grounding electrode system as part of the install.
Panel-level protection plus point-of-use devices at your most sensitive equipment is the configuration that actually works.
With Hill Air Force Base next door, a lot of Roy homes turn over on a PCS timeline, and the home inspection is where an old panel becomes a negotiation.
Permits: we pull the Roy electrical permit where the work requires one and schedule the inspection.
Power company: Rocky Mountain Power serves Roy. We coordinate the meter disconnect and reconnect for panel and meter work.
Local conditions: With Hill Air Force Base next door, a lot of Roy homes turn over on a PCS timeline, and the home inspection is where an old panel becomes a negotiation.
You never deal with the city or the utility. That is our job.
We work throughout Roy and Weber County, including Hill Field Road and the Hill Air Force Base gate.
A Type 2 device at the panel clamps the voltage transients that come down the service conductors, which is the majority of what damages equipment. It is not a substitute for good grounding, and it does not replace point-of-use protection at your most sensitive electronics — it works alongside both.
With Hill Air Force Base next door, a lot of Roy homes turn over on a PCS timeline, and the home inspection is where an old panel becomes a negotiation.
It cuts what reaches them substantially. For expensive electronics we still recommend a point-of-use protector or a UPS in addition, so you have two stages rather than one.
Most installations are a single short appointment at your existing panel. If your grounding system needs correction first, we tell you before we schedule rather than after.
Our workmanship carries a five-year warranty, and the device itself carries the manufacturer’s own coverage. We register it for you.
Run the numbers yourself with our free EV charger, panel-upgrade, energy and generator calculators. No email required.
Licensed, insured and ready now. Free estimates, upfront pricing, five-year warranty.